Set Up Instructions
6. Follow the filter media setup instructions on
the previous page which apply to your filter.
Remember to remove all media from the plastic
bags and rinse in tap water to remove excess
dust. The simplest way to do this is empty the
correct media into its basket and run tap water
through it. Rinse the inside of the canister body
in tap water also, remember
DO NOT USE ANY
SOAPS OR DETERGENTS.
Fig 4
7. Once all the filter media and the canister has
been washed and the sponges have been
inserted into the filter baskets place the filter
media baskets in the correct order (Refer to
previous page) back into the canister body.
Ensure the filter inlet pipe has the black sealing
O-ring at the top of it and that the baskets sit flat
on top of each other. The sealing O-ring on the
top filter basket is attached to the bottom of the
head unit. Fig 5
8. Ensure the filter grid is then placed back on
top of the last filter basket. This is very impor-
tant. Fig 6
Fig 1
Fig 2
Fig 3
Fig 4
Fig 5
1. Remove the 2 boxed accessory packs and
the filter unit from the box.
2. Open the filter unit. To do this release the 4
clips located on the corners of the filter. Fig 1
3. Lift the head unit off the canister body. Place
it somewhere safe where it will not be stepped
on or broken. Fig 2
4. Take the canister body to the sink. Ensure
the area is clean and free from detergents.
5. Remove the filter grid and the filter media
baskets from the canister. Fig 3
