8
5
Repeat above steps to set other 3 timers
6
Hold 3 seconds to save setting
7
or
Check 4 timers to make sure there is no invalid setting
Note:
Overlap setting of time will be considered as invalid, the pump will only run based on the
previous valid setting.
During timer setting, if you want to return to the previous setting, hold both
for 3 seconds.
5.8 Parameter Setting
Restore factory setting
Under off mode, hold both
for 3 seconds
Check the software
version
Under off mode, hold both
for 3 seconds
Enter parameter setting
as below
Under off mode, hold both
for 3 seconds; If
current address does no need to be adjusted, hold both
to next address
Parameter
Address
Description Default
Setting
Setting
Range
1
PIN3
100%
30~100%, by 5% increments
2
PIN2
80%
30~100%, by 5% increments
3
PIN1
40%
30~100%, by 5% increments
4
Self-priming/
Backwash
capacity
100%
80~100%, by 5% increments
5
Control mode of
Analog Input
0
0: current control
1: Voltage control
