4
Step 4
3
5
9
Step 2
4
5
4 I
n.
4
Step 3
1
2
3
5
4 I
n.
Step 2:
Snap the Deflector Wheel #4, onto the Hose Section #5, with the curved fins of the deflector facing up.
The Deflector needs to be 4 inches from the bottom of the female end of the Hose #5.
For corner or end installations
If your skimmer or wall vacuum fitting is located at the corner or end of your pool,
use enough hose sections to reach the farthest point in the pool, plus one (1) section.
Hose Assembly
After determining the amount of Hose Sections #5 needed, Connect all sections.
Make sure that this is done with the hose fully submerged under the water.
Angle the hose so that all air is removed from each hose section before you connect
them together.
2
For center installations
If your skimmer or wall vacuum fitting is located at the center of your pool, use
enough hose section to reach the farthest point in the pool, plus two (2) sections.
Step 1:
Stretch the Skirt #2, over the Foot #1, by starting at the corner of the Foot #1. Rotate the skirt in a circular
direction while stretching the Skirt #2 over the Foot #1. Once you have completed a full circle the Skirt #2 should
now be resting freely in the skirt channel of the Foot #1.
1
2
Step 1
Step 3:
Insert the assembled Body #3, into the female end of the Hose Section #5,
Step 4:
Clip one Hose Weight #9, onto the Hose Section #5 about 1 foot above the Deflector Wheel #4. The position
of this weight will be changed later to adjust the EZ-Vac’s vacuuming angle.