9
PRO POOL LIFT - ASSEMBLY INSTRUCTIONS
1.
Attach Seat
belt to the
seat as
shown.
2.
Install the PRO POOL LIFT onto the four
(4) anchors using the supplied 1/2 x 1-1/2”
stainless steel hex-head bolts and 1/2"
stainless steel flat washers. Make sure all
bolts are tight before using the lift.
3.
Plug the handset cable into the large handset
socket on the bottom of the control box. Be
sure you press the cord end firmly into the
socket until you are sure it is all of the way
into the socket. Failure to fully push the
remote cord into the socket may result in
faulty or interrupted operation.
4.
Before installing the battery, place it on the charging unit and let it charge for 24
hours. Make sure the orange “charge” light illuminates when the battery is being
charged.
5.
Remove the fully-charged battery from the charger and install it on top of the Control
Box. The battery will line up square with the control box, and will ‘click’ when it
locks in place properly. The lift will only operate when the battery is mounted
properly.
WHEN NOT IN USE STORE THE BATTERY ON THE CHARGER. DO NOT
LEAVE THE BATTERY ON THE LIFT WHEN NOT IN USE!
