Copyright © 2019 Aqua Creek Products All Rights Reserved
Revised 6/14/19
24V SOLAR PANEL
ASSEMBLY
SOLAR CHARGER
MAST POLE
SOLAR CHARGER
MOUNTING BRACKET
FUSE BOX
CONTROL BOX
CONNECTOR
1/4" BUTTON HEAD
1/4" FLAT WASHER (2)
1/4" NYLOCK NUT
Unpacking and Installation
Before installing the 24V Solar Charger to the lift, fl ip-up the 24V Solar Panel Assembly and install the
1/4” button head bolt as shown in the diagram above. The 24V Solar Charger bolts directly to the mast
of the lift and may be left on the unit 24 hours a day. In most cases this will mean the battery will not
need to be charged during the day, or for heavy usage will not need to be put on the AC wall charger as
often. To install the 24V Solar Charger, remove the four (4) 3/8” Nylock nuts and fl at washers from the lift
as shown, and install the charger. The control box connector plugs directly into the control box as shown
above and on page 8.
SOLAR
CHARGER
3/8"
NYLOCK (4)
3/8" FLAT
WASHER (4)
CHARGER
CABLE
CONTROL
BOX
PLUG INTO
CONTROL BOX
24V IN/OUT
(FAR RIGHT)
FUSE BOX
2
