Parts Needed:
Nozzle Base
x 1
.6 Nozzle Tip
x 1
Flow Stopper x12
Rubber
Plug x1
Bolt
x1
Screw
x14
1.25 OD Washer
x11
1. Remove Flare from Nozzle Base:
Remove the Flare from the Nozzle base, set aside.
(Save for use with other patterns)
2. Install Flow Stoppers to the Nozzle Base:
Insert 12x Flow Stoppers into the bottom of
the Nozzle Base, secure with 12x screws
Fusion Series:
TORNADO
3. Attach the Nozzle Base
Stack 11 Washers in the cup
of the Outflow
Finally secure the Center
(.6)Nozzle Tip with the plug
inserted to the Nozzle base
using 2x screws
Secure the Nozzle Base to the
unit using the bolt that goes
through the center hole
Make sure Rubber Plug is
inserted into the bottom of
the .6 Nozzle Tip
A6
