FARBWERK
USB device. The black wires (GND) are to be connected to
the side of the missing pin, see picture with colored pin as-
signment.
Pin assignment:
Pin 1: +5 V (red)
Pin 2: D-
(white)
Pin 3: D+ (green)
Pin 4: GND (black)
Pin 5: not connected
5.5.
5.5.
5.5.
5.5. aquabus 1/2
aquabus 1/2
aquabus 1/2
aquabus 1/2
Connector for communication with other Aqua Computer devices. Use a compati-
ble aquabus cable (not included in delivery, article no. 53122/53162) to connect
the farbwerk controller board to a suitable connector of a compatible device, for
example an aquaero. USB and aquabus interface can be used at the same time.
Pin assignment: Pin 1: GND
Pin 2: SDA
Pin 3: SCL
Compatible aquabus devices:
●
aquaero 6 XT (53146, 53206, 53250, 53251, 53262, 53263)
●
aquaero 6 PRO (53145, 53253)
●
aquaero 6 LT (53234)
●
aquaero 5 XT (53089, 53125, 53249)
●
aquaero 5 PRO (53090, 53252)
●
aquaero 5 LT (53095)
5.6.
5.6.
5.6.
5.6. Temperature sensors
Temperature sensors
Temperature sensors
Temperature sensors
Connector for up to four temperature sensor.
Pin assignment: Pin 1/3/5/7: Signal 1-4
Pin 2/4/6/8: GND
Compatible sensors:
●
Temperature sensor inline G1/4 (53066)
●
Temperature sensor inner/outer thread G1/4 (53067)
●
Temperature sensor G1/4 (53147)
●
Temperature sensor plug&cool (53025)
●
Temperature sensor 70 cm (53026)
5.7.
5.7.
5.7.
5.7. Status LED
Status LED
Status LED
Status LED
The blue status LED should always be active if power is supplied. For revisions 1
and 2 (black circuit boards), the LED is soldered into the circuit board and can not
be removed.
Revision 8 (white circuit boards) only: The status LED is removable and can be in-
serted from both sides. A red LED is also included in delivery and can be used in-
- 6 -
Aqua Computer GmbH & Co. KG
© 2014-2020
Gelliehäuser Str. 1, 37130 Gleichen
computer
aqua
