AQUADUCT
7.
7.
7.
7. Installation
Installation
Installation
Installation of the
of the
of the
of the PC interface circuit board
PC interface circuit board
PC interface circuit board
PC interface circuit board
Install the circuit board in a free slot of
your case. The slot does not have to
have any connection on the mother-
board.
Please pay special attention to the jump-
er J1 on the interface board when using
an aquaduct 360 XT or 720 XT, as cor-
rect setting of this jumper is crucial for
correct operation!
The two holes in the bracket are
equipped with rubber protectors for safe
lead-through of the coolant hoses.
7.1. Connector „power“
7.1. Connector „power“
7.1. Connector „power“
7.1. Connector „power“
Please connect a HDD power plug of
your PSU to this connector. Do not use
excessive force but double check the po-
larity of the plug if having trouble to con-
nect.
7.2. Connector„pump rpm signal“
7.2. Connector„pump rpm signal“
7.2. Connector„pump rpm signal“
7.2. Connector„pump rpm signal“
This connector supplies a artificial rpm signal that is generated by the
controlling unit of the aquaduct. This rpm signal can for instance be
configured to be switched off in case of an alarm and thereby can be
used for status monitoring of the aquaduct. If connected to a fan con-
nector of the motherboard, depending on BIOS functionality and con-
figuration, an alarm power-off can be realised. For details on BIOS
configuration, please consult the manual for your motherboard,
7.3. Connector „flow“ (aquaduct 240 PRO only)
7.3. Connector „flow“ (aquaduct 240 PRO only)
7.3. Connector „flow“ (aquaduct 240 PRO only)
7.3. Connector „flow“ (aquaduct 240 PRO only)
Usable for connecting an optional flow sensor. Do only use aqua com-
puter sensors and cables!
- 16 -
Aqua Computer GmbH & Co. KG
© 2007-2009
Gelliehäuser Str. 1, 37130 Gleichen
