AQUADUCT
6.4. Installation of “3-nose-mounting kits” - Socket 370, A
6.4. Installation of “3-nose-mounting kits” - Socket 370, A
6.4. Installation of “3-nose-mounting kits” - Socket 370, A
6.4. Installation of “3-nose-mounting kits” - Socket 370, A
For this fastening version two laser-processed
high-grade brushed steel sheets and four
pressure-springs are supplied with the cuplex.
First slide the brushed high-grade stainless
steel sheets through the slits in the Plexiglas lid
from the bottom. One of the two brushed
high-grade stainless steel sheets only fits
through the slit on
one side of the Plexiglas lid, therefore confusion
is impossible. The slightly differing spring dis-
placements on both sides cause the pressure to
finally concentrate exactly on the processor
core (“balanced load”). Now insert the pressure
springs into the metal sheets above the lid, as
shown on the picture. The cooler can be moun-
ted onto the core of the processor now, which should already be pre-
pared with heat-conductive paste as described above.
Make sure that the core of the processor is
located centrally below the copper bottom of
the cooler and that the longer part of the
Plexiglas lid which sticks out is situated above
the detachment mechanism of the socket. To
avoid damage to the core the pressure for
mounting has to be applied exactly perpen-
dicular to the surface of the core. Compress
the springs putting the thumb balls on the
stainless steel sheets from above and taking
hold of the lid from below and hook the stain-
less steel sheets under the plastic noses of the
socket. Avoid the cooler to get stuck, since this
will risk a corner of the die to break off. Do
not hook in one side after the other!
- 14 -
Aqua Computer GmbH & Co. KG
© 2007-2009
Gelliehäuser Str. 1, 37130 Gleichen
