Shaker type dust collector
5
4 NORMAL USE
The MAXIVIBE unit is designed to filter harmful dusts from the air resulting from a fabrication
process. Each MAXIVIBE dust collector is built based on the request and information supplied
by the customer for a given application and should not be used for any other application unless
approved by A.Q.C. Inc.
The dust collector should be used at intervals in order for the filter envelope to be cleaned at the
end of each cycle of usage.
WARNING!
Flammable and /or explosive solids and solvents consist
of a fire or explosion hazard within the collector cabinet.
Such matters should not be filtered unless the collector
is designed to that effect an equipped with an explosion
venting system and/or a fire extinguishing device. Special
care is mandatory when the collector is used for flammable
and/or explosive solids and solvents. Any object on fire or
bearing a fire hazard such as sparks created by grinding/
buffing or smoking material should not be allowed to enter
the collector cabinet as it may cause a fire or explosion.
5 OPERATION
During normal use, dusty air is introduced into the MAXIVIBE inlet. The smaller particles are
vacuumed to the filter envelope and the larger particles fall into the dust storage compartment.
The smaller particles are stored into the filter envelope and clean air is pushed toward the collector
outlet.
6 CLEANING OF THE FILTER ENVELOPE
6.1 Automatic shaker (optional)
When the collector is shut down, a timer starts the shaker sequence after the fixed time delay of
stopping the motor has expired. The shaker then starts for a predetermined run-time. Motor and
control panel electrical power must be maintained to start the shaker sequence.
6.2 Manual shaker
When the collector is shut down, the operator must wait until the motor has stopped completely.
The cleaning is made by vigorously shaking the handle on the side of the unit.
