Shaker type dust collector
14
Photo 1
14.2 Installation of the filter envelope
1 .
Open the access door to filter envelope and
unhook the rubber bands holding the filter
envelope to the shaker frame (Figure 1).
2 .
Remove the rubber bands from the filter
envelope.
3 .
Unbolt the lower frame of the filter cabinet
(Figure 2).
4 .
Remove the filter envelope and its frame from
the cabinet (Figure 3).
5 .
Unbolt stop bars from the frame (Figure 4).
6 .
Align the new filter envelope with the frame and
install the stop bars.
7.
Install the filter envelope and frame back into
the collector. Tighten the bolts securely to
ensure the frame is sitting tightly onto the seal.
8 .
Slide the rubber bands back into the new filter
envelope and hook onto the shaker frame.
(Figure 5).
9 .
Close and lock access door.
Photo 2
Photo 3
Photo 4
Figure 5
Figure 2
Figure 1
MAXITUBE
Page | 9
Baghouse Dust Collector
4.
Install a ground wire to the unit
.
5.
Lift t
he filte
r cabinet using the lift lugs. Using spikes, position the cabinet
above the dust storage section making sure to align the cabinet bolt holes
with the dust storage bolt holes.
6.
Lower t
he filte
r cabinet onto the dust storage section and align the bolt holes.
7.
Attach t
he fil
ter cabinet to the dust storage section using the supplied nuts,
washers and bolts. Tighten bolts for an adequate seal.
Figure 3
Support
plates
Support
legs
Cross braces
WARNING
Apply two strips of butyl adhesive on the dust storage section upper
outline. One strip should be applied inward of the bolt holes and one
strip outward of the bolt holes (Figure 4).
Figure 4
WARNING
The use of a spreader is recommended to avoid
d
amages to the filt
er cabinet.
Unside bag
removal
MAXITUBE
Page | 9
Baghouse Dust Collector
4.
Install a ground wire to the unit
.
5.
Lift t
he filte
r cabinet using the lift lugs. Using spikes, position the cabinet
above the dust storage section making sure to align the cabinet bolt holes
with the dust storage bolt holes.
6.
Lower t
he filte
r cabinet onto the dust storage section and align the bolt holes.
7.
Attach t
he fil
ter cabinet to the dust storage section using the supplied nuts,
washers and bolts. Tighten bolts for an adequate seal.
Figure 3
Support
plates
Support
legs
Cross braces
WARNING
Apply two strips of butyl adhesive on the dust storage section upper
outline. One strip should be applied inward of the bolt holes and one
strip outward of the bolt holes (Figure 4).
Figure 4
WARNING
The use of a spreader is recommended to avoid
d
amages to the filt
er cabinet.
Unside bag
removal
Drawing 5
FILTER ENVELOPE
SHAKER FRAME
SHAKER SHAFT
RUBBER BAND
