Industrial Exhaust Blower
8
9.4 Installation of MAXIDRIVE fan with
MAXIREACH extension boom:
1.
Bolt or weld MAXIREACH boom base (1) to
support structure.
2.
Position fan on boom base. Ensure fan
orientation is appropriate for exhaust
direction.
Note:
Optional fan/boom base reducer will be
required if boom outlet size does not match fan
inlet size.
Note:
Optional fan outlet silencer will be installed if required.
9.5 Installation of MAXIDRIVE fan with MAXIREEL exhaust hose reel:
Note:
AQC usually supplies fan and reel factory assembled. If fan is shipped separate, bolt fan
flanged inlet to hose reel flanged outlet. Ensure fan orientation is appropriate for exhaust direction.
Drawing #5
Drawing #6
MAXITUBE
Page | 9
Baghouse Dust Collector
4.
Install a ground wire to the unit
.
5.
Lift t
he filte
r cabinet using the lift lugs. Using spikes, position the cabinet
above the dust storage section making sure to align the cabinet bolt holes
with the dust storage bolt holes.
6.
Lower t
he filte
r cabinet onto the dust storage section and align the bolt holes.
7.
Attach t
he fil
ter cabinet to the dust storage section using the supplied nuts,
washers and bolts. Tighten bolts for an adequate seal.
Figure 3
Support
plates
Support
legs
Cross braces
WARNING
Apply two strips of butyl adhesive on the dust storage section upper
outline. One strip should be applied inward of the bolt holes and one
strip outward of the bolt holes (Figure 4).
Figure 4
WARNING
The use of a spreader is recommended to avoid
d
amages to the filt
er cabinet.
Unside bag
removal
Figure 5
Figure 6
3
2
1
4
5
2
1
