APW Wyott HR-, Инструкция по установке и эксплуатации

Страница: 10 / 28

User Lock:
When locked, the user is not allowed to make any
time or temperature adjustments. The only valid
entries to the control are press of the “ZONE” keys
to start or advance the cycles per above. If a user
tries to change TIME or TEMP settings when
locked, the control will beep and display the locked
display shown below.
To LOCK or UNLOCK : Press and hold the “TIME”
key for 10 seconds.
HEAT
HEAT
HOLD
HOLD
1
2
HEAT
HEAT
HOLD
HOLD
1
2
LOCK DISPLAYS
LOCKED UNLOCKED
Time/Temp Adjust:
The control allows independent TIME & TEMPERATURE adjustment for each zone. This assumes the
User Lock is off, i.e. they have access to the programming.
1. The unit must be OFF . Advance through cycles via ZONE key.
2. Press and hold the desired ZONE key for 3 seconds.
A. The unit defaults to HEAT temp, and ZONE LED flashes;
B. Adjust
HEAT temp with arrow keys;
C. Press TEMP key to accept and advance to HOLD temp, adjust;
D. Press TIME key to accept and advance to TIME , adjust;
E. Press ZON E key at any time to accept and exit.
3. Repeat for the other zone as needed.
4. Press the ZONE key to start with the new settings.
NOTE: By requiring the unit to be cycled to OFF, it insures the time or temperature settings will not be
changed accidentally.
225
HEAT
HOLD
2
In this example the User
pressed and held ZONE
2, the LED indicator for
ZONE 2 flashes & HEAT
temp displays.
Adjust ZONE
Temp/Time Settings
----
HEAT
HOLD
1
Unlimited HOLD TIME
Hold Time Bypass:
For unlimited HOLD TIME, per the instructions above, increase the hold
time to the maximum setting. The next increment beyond is infinite, and
the display will show as follows:
Temperature & Time - Recall & Display Properties:
During operation, the display will show the following parameters. A press on either the “TIME” or “TEMP”
key will respond as follows:
COOK Countdown timer Actual Temp Countdown timer
HOLD Set Point Temp Actual Temp Elapsed HOLD time
HOLD-DONE Alternate “DONE” & Set Actual Temp Elapsed HOLD time
Point Temp 1 second each
Mode Default Display Press “TEMP” Press “TIME”
Display Priorities - Hot Dog
NOTE: Both displays respond the same. The current cycle LED’s will remain lit at this time.
Temperature Toggle (°F and °C):
Press and hold the “TEMP” key for 10 seconds. The control beeps, and
then displays °F or °C as appropriate. Repeat to toggle back.
Temperature Increment (°F and °C):
The display and adjustment up or down using the arrow keys will
increment temperature up or down as follows:
°F / °C Toggle
Temperature Increments
Units Increments
°F 5°F
°C 2°C
10