APW Wyott HHP-212, Инструкция по установке и эксплуатации

Страница: 7 / 17

7
4. LIGHTING INSTRUCTIONS
HHP and HHPS Gas Open Burner Ranges are furnished with either a pilot safety valve or a standing pilot
(not available in the European Community). Please follow the instructions for your unit.
Operation of the gas valve pilot:
1.
Turn knob on the main gas valve to the pilot position
2. Depress knob to start gas flow to the pilot valve
3. Light pilot valve
a. Using a match or taper
4. Hold in knob for 15 to 30 seconds to heat up the thermocouple
5. Release knob and turn to the desired gas flow position
a. If pilot goes out repeat steps 1-4, some thermocouples will take longer to heat up
( Not Available in the European Community )
The pilot lights on the broilers have been set at the factory. A screwdriver may be required for the first lighting
to adjust the flame for your elevation.
1.
Turn off the manual shut off valve and wait 5 minutes to clear the gas.
2. Turn all knobs to the "OFF" position.
3. The valve can be accessed through an opening in the front panel or remove the cooking grates and
light the pilot from above.
4. Turn the manual shut off valve on.
5. Hold an ignition source (match) to both openings on the pilot tube. When the flames are established,
remove the ignition source.
6. Turn the burner knobs to “ ” . If the burner does not ignite, promptly open the pilot valve more. If the
pilot flame appears larger than necessary, turn it down and reset burner ignition. The pilot flame should
be as small as possible but large enough to guarantee reliable ignition of the burners when the knobs
are turned to
.
If the pilot light should go out for any reason:
Promptly shut off all gas at the manual shut off valve.
Turn off all knobs and pilot valves; wait 5 minutes to clear gas.
Relight following steps 4 through 6 under
Since the burner is lit from constantly burning pilot, turn knobs to "HI" to put the unit in operation; then adjust
to any desired position between "LO" and "HI".
To light burner, turn knob to "max." then back off to the desired flame level. The range of adjustment is
virtually infinite between high and off. (At the small flame, there is a pre-set low).
When the broiler is first heated, it will smoke until oil used in manufacturing, preservation and dust from
storage and shipping are burned off. An hour at "max." on all burners is usually sufficient.
Turn knobs off and let cool
For first cooking, set the grates at maximum tilt position and preheat before broiling. You will have to
experiment with knob settings and grate position for each particular item.
Keep the grease/water pan with sufficient water to cover the entire bottom.
Clean regularly. Grates may be removed for washing in the sink. Brush out carbonized particles.
Thoroughly wash the grease/water pan.
Never attempt to move a grill section while cooking. An unexpected flare could cause severe injury. Turn off
the unit, let it cool and use potholders and/or gloves to reposition or remove. The space between the legs at
the bottom admits combustion air. DO NOT BLOCK THIS SPACE.
Pilot Operation Flame Failure Gas Valve:
Standing Pilot Lighting Instructions:
Standing Pilot Lighting Instructions.
LIGHTING THE MAIN BURNER:
CAUTION
HI
“ HI ”
RELIGHTING PILOT
l
l
l
l
l
l
l
l
l