APS LSC, Инструкция по установке и эксплуатации

Страница: 7 / 16

7
* factory setting
LSC
Warning:
If you are using a single Basic Module BM the address has to be set to the stand alone mode
(all LED are blinking) which is factory setting. Otherwise, a bus error will occur.
Important:
If you are in the module ID address setting process and do not press any button for six
seconds, the module will switch back to operation mode without saving your changes. Please
note that changing the module ID address may cause a bus error on an other module.
LED
blinking
ID-address
LED
blinking
ID-address
1 0 6 5
2 1 7 6
3 2 8 7
4 3 1 – 8* 8*
5 4
Factory settings:
Please refer to the following points to set a Basic Module BM back to factory settings:
o
Turn of the supply voltage.
o
Press and hold the two buttons lamp test and horn acknowledgement, then turn on the
supply voltage.
o
The module acknowledges the restoration of the factory settings by beeping three
times.
Button horn acknowledgement
Button lamp test
Important:
The procedure has to be repeated for every module you wish to set back. The restroing of
the factory settings will also change the module address to stand alone, this may cause a bus
error.