APRILIA QUASAR 125 2003, Руководство по ремонту

Страница: 63 / 168

ENGINE
QUASAR 125-180
3 - 14 -
00
Release 00/2003 - 09
1
2
3
4
4
5
5
3.2.11 REFITTING THE CAMSHAFT
"
Remove flywheel housing, see 3.2.2 (REMOVING FLYWHEEL UPPER
AND LOWER HOUSINGS).
"
Move piston to bottom dead centre, by taking care that the flywheel notch
(T) is opposite (180°) to the pan fin.
"
Turn camshaft so as to fully close both valves.
"
Drive chain onto toothed gear by taking care that, after being installed onto
camshaft, the reference marks (1) are parallel with the head edge.
"
Remove tensioner top screw (2) and remove the spring from the inside.
"
Push on the stop tooth to move back rocker arm.
"
Change seal and refit mount. Tighten the two screws (3).
"
Fit spring and tensioner screw, then manually turn crankshaft by 3 or 4 turns
and check once more timing reference marks correct positioning.
Before turning crankshaft by hand, check that spark plug is not into its
location.
"
Proceed to valve adjustment, see 3.2.12 (ADJUSTING VALVE
CLEARANCE).
"
Refit the complete camshaft mount and, working crossways, tighten the four
screws (4).
"
Refit head cover and, working crossways, tighten the four screws (5).
ProCarManuals.com