APRILIA ATLANTIC 300 -, Руководство по обслуживанию станции

Страница: 70 / 275

Electric characteristic
Secondary coil winding resistance
2.9 kOhm ± 10%
Primary coil winding resistance
0.2 Ohm ± 10%
Pick-up check
•
Disconnect the pick-up connector.
•
With a pocket tester (1000 Ohm scale) measure the resistance between the terminals of the
red and white cables. The measured resistance value must be between 105 Ohm ± 10% (at
20 °C).
•
If the resistance is infinite or lower than the set value, the pick-up needs to be replaced.
The side stand " 1 " must rotate freely and smoothly.
Carry out the following checks:
•
The springs «2» should not be damaged, worn, rusty or slacken.
•
The stand should turn freely: grease the joint if required.
A safety switch « 3 » is installed on the side stand « 1 » to inhibit or stop engine operation when the side stand « 1 » is lowered.
To check the safety switch « 3 » correct operation:
•
Sit on the vehicle in riding position.
•
Fold up the side stand again «1».
•
Start the engine.
•
With the throttle grip released and the engine at idle, lower the side stand «1», which will activate the safety switch
«3».
At this stage:
- the engine should stop;
- on the instrument panel, the side stand down warning light should be on.
NOTE
IF THIS DOES NOT OCCUR, REPLACE THE SWITCH «3».
Electrical system
ATLANTIC 300 i.e.
ELE SYS - 70