Appsys ProAudio Flexiverter AES3, Руководство пользователя

Страница: 8 / 22

User's Manual
4. AUDIO ROUTING
The flexiverter can operate in various routing modes, allowing you to pass audio
between the available interfaces (AES3, AUX and FlexLink) in many different ways.
The LEDs in the "MODE" section indicate the involved interfaces.
4.1. Modes and indication
Mode (route between) Operation
(Example) Setup
(blinking alternately) Remarks
AES3(+AUX)
<> FlexLink
⬤
⬤
⬤
⬤
AES3 Port A
AES3 Port B
AUX
FlexLink
❇
❇
❇
◌
◌
◌
◌
❇
AES3 Port A
AES3 Port B
AUX
FlexLink
AUX LED only active when card
installed
AES3 <> AUX
⬤
⬤
⬤
◌
AES3 Port A
AES3 Port B
AUX
FlexLink
❇
❇
◌
◌
◌
◌
❇
◌
AES3 Port A
AES3 Port B
AUX
FlexLink
Only available with AUX
installed. Additional split of
everything to FlexLink
2
AES3 A <> B
+split to AUX
⬤
⬤
⬤
◌
AES3 Port A
AES3 Port B
AUX
FlexLink
❇
◌
❇
◌
❇
❇
◌
AES3 Port A
AES3 Port B
AUX
FlexLink
Split and/or translate between
Tascam and Yamaha pinout
cables. Additional split of
everything to FlexLink
2
LED color Meaning
◌
off Interface not active / involved
⬤ green IN and OUT valid
⚪
white OUT valid, but no IN detected
⬤
red No valid signal or no valid clock.

If the clock LEDs show red, make sure the clock mode is set
correctly and a valid clock is supplied.

If the clock LEDs show green, the clock is ok but the input is not
detected. Check the respective connection.
❇
red blinking Interface is currently booting and not yet active
❇
yellow blinking Mode setting active: Alternately blinking LEDs indicate the interfaces
between which data is converted; constant lit LEDs indicate splitting
destinations.
Press MODE button again to cycle through available modes. After 4
seconds, the selected mode is applied automatically.
2 All incoming data is also split (output) to FlexLink: AES3 A+B are split to Lane 1 (ch1-64), AUX is split to
Lane 2 (ch65-128). The split is not indicated on the LEDs for clarity but is always active.
8