Installation
General Use
F.A.Q.
Warranty
Troubleshooting
Appendix
Safety
V2.1 [2013-1-14]
8
9505 / 9505A Docking Station
Installation
Press the connector from your hands-
free headset into the Headphone jack as
shown.
NOTE:
2.5mm Plugs are standard in most hands-
free handsets but if needed, you can
purchase adapters at most electronics
stores.
Optional Wire Connections
The steps on this page may not be applicable to every installation, and should be considered optional.
Attach Hands Free Audio Headset
(not included)
Attach the serial cable by first aligning the
asymmetric pin pattern with the receptacle,
and then by pressing the plug into place
until it stops. Next hand-tighten both of the
thumb-nuts until snug.
IMPORTANT:
Though a screw driver slot is supplied on
most cords, it is unnecessary to torque
the thumb screws beyond “finger-tight”.
Attach Serial Cable
Connect your DPL Digital Handset to the
RJ-45 jack as shown. The plug should be
pressed into the socket until an audible
‘click’ is heard, indicating the plug is fully
seated and locked in position.
IMPORTANT:
This port uses a common RJ45 connector,
but it should be noted that it will not
support a connection to anything other
than a DPL Digital Handset. Additionally,
only one DPL handset is supported
Attach DPL Digital Handset
(not included)
IMPORTANT:
If you are in doubt about the mounting options or the connectivity at any stage of this installation, please contact an ASE
representative for assistance. They will be able to guide you through your specific installation options more clearly.
