
Unpacking
Preparation
Installation
Warranty
Operation
Appendix
Overview
REV-3.0 [3-17-11]
9
ComCenter-II ‘Outdoor’
Product Manual
Installation
Installation
Once you have successfully “Pre-Use” tested the ComCenter device, you will be ready to proceed with system
instalation. Step-by-Step illustrations for this process are provided below.
Attach the ComCenter mounting bracket to
the top of a Threaded 1” diameter pipe by
spinning the bracket clockwise. Once the
bracket no longer turns freely, lock it in place
using the set-screw as shown.
Attaching Bracket to Pole
Feed the Communications cable down the bracket (and pipe) toward your
designated communications area. It is important to leave yourself 6-8” of extra
cable that will serve as a service loop while attaching the ComCenter Outdoor
Unit.
Routing Cables
Pull the opposite end of the communications
cable through the wall and attach it to the
supplied wall-plate adapter. Next attach the
wall-plate to the wall as shown.
Connecting the ComCenter
NOTE:
Usable Mounting Poles measure 1” in
Diameter and are end-threaded with
a 14 thread-per-inch thread.
IMPORTANT:
Be sure the exposed cable contains the “Female” connector, and not the “Male”.
IMPORTANT:
Be sure the exposed cable contains the
“Male” connector, and not the “Female”.