If you wish to make a direct connection to the mains, an omni polar switch with a separation gap
between the contacts of at least 3 mm, with suitable R.C.D. / R.C.C.B., current rating for the load
and complying with the regulations in force, must be installed between the appliance and the
mains. The switch must not break a contact in the yellow/green Earth wire.
The Brown live wire (connected to the “L” terminal of the terminal board) must always be
connected to the live wire of the power supply.
The Blue neutral wire (connected to the “N” terminal of the terminal board) must always be
connected to the neutral wire of the power supply.
In all cases, the power supply lead must be positioned so that it does not reach a temperature
50
o
C above the room temperature at any point.
Replacing the power supply lead
If the lead has to be replaced, only HO5RR-F or HO5RN-F type cables suitable for the load and
the operating temperature must be used. In addition, the yellow/green earth wire must be about 2
cm longer than the live and neutral wires.
Adapting to the different types of gas
MAX
OUTPUT
MIN
OUTPUT
G20
20mbar
G30
28-30mbar
BURNER TYPE
Kw
Kw
Jet Size
mm
Jet
Size
mm
Small
Auxiliary
1.00
0.60
0.72
0.49
Medium
Semi-Rapid
1.85
0.90
0.97
0.67
Large Rapid
3.0
1.2
1.15
0.87
Gas intake connection G.1/2
″
Electricity supply 220-240v~50/60Hz
The wires in the mains cable are
coloured in accordance with the
following code:
Green & Yellow = Earth,
Blue = Neutral,
Brown = Live
