APG True Echo PRL Series, Руководство пользователя

Страница: 12 / 16

8 Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • sales@apgsensors.com
• Unscrew top lid of radar, exposing electrical terminals.
• Feed wires from your control system through 1/2” NPT conduit hole on side of radar.
• Attach the wires of your control system to the radar according to the appropriate Power & Control
Wiring Diagram on page 5 and 6.
• Secure conduit in 1/2” NPT hole.
• Replace lid of radar.
• Electrical Installation

NOTE : Do not mount the sensor where the beam will intersect objects such as fill
streams, pipes, ladder rungs, wall seams, or corrugated tank walls.
• Ensure that power (VAC or VDC, control power, and communication power) to the radar is off.
• Unscrew top lid and detach wires from terminals.
• Disconnect conduit from radar.
• Remove the radar and store it in a dry place, at a temperature between -40° F and 140° F.
• If the radar was installed in a hazardous location, ensure that the cables will not energize while the
sensor is disconnected.
• Removal Instructions
 DANGER : Do not disconnect equipment installed in hazardous locations unless power
has been switched off or area is known to be non-hazardous.
• Download the Probe Gateway software zipfile from http://apgsensors.com/support .
• Open the zip file.
• Choose “Install” from the options at the top of the zip file window.
• The installation process will prompt you as needed to complete the installation.
• Software Installation