PG7
Rev. A2, 07/16
20
Automation Products Group, Inc.
OUTPUT:
Used to configure any optional gauges outputs, such as an analog signal or
trip point relays.
Analog Low (AL SET) & Analog High (AH SET) Setpoints:
Allows the user to define the reading values associated with the Low Analog
signal (i.e. 4mA or 0V) and the High Analog signal (i.e. 20mA, 2V or 5V).
NOTE:
The analog setpoints must be entered using the gauge’s base unit of
measure (typically PSI).
Setting the Analog Signal Span:
Step 1
:
Press the
On/Off
button once to enter the main setup menu.
Step 2:
Press
(Z)
to cycle through the options until
OUTPUT
is displayed.
Step 3:
Press
(S)
to access the Output Settings menu.
Step 4:
Press
(Z)
to cycle through the options until
AL SET
is displayed.
Step 5:
Press
(S)
to access the Analog Low setpoint value. A 5-digit number
will appear with the first digit flashing.
Step 6:
Press
(Z)
to change the value of the first flashing digit (options: 0-9
or “-”).
Step 7:
Press
(S)
to accept the value of the flashing digit and advance to the
next digit. Repeat steps 6 and 7 until the desired Analog Low reading is
fully entered. After the last digit is accepted by pressing
(S)
, the display
will return to the main options menu.
Step 8:
Press
(S)
to reenter the Output Settings menu.
Step 9:
Press
(Z)
to cycle through the options until
AH SET
is displayed.
Step 10:
Repeat Steps 5-7 to enter the Analog High setpoint value.
Step 11:
To exit the output menu, press
(Z)
until
EXIT
is displayed and press
(S)
to exit to the main setup menu.
www.
.com
1.800.561.8187
