Table of Contents
© 2014 Apeks
CAUTION:
Failure to correctly reassemble the shoulder strap could cause strap
assembly to come undone during a dive, resulting in loss of equipment.
Customizing the Shoulder Hardware
1.
Remove epaulets from the shoulder strap webbing.
2.
Unweave webbing from 3-bar plastic slide and rectangular
plastic loop.
3.
Remove 3-bar plastic slide from webbing. Pull webbing
out from sewn-in shoulder strap loop.
4.
You now have the ability to add or remove hardware
according to your needs.
4.
Weave webbing through 3-bar plastic slide and tighten,
making sure that there is at least 0.5 inches of excess
webbing extending past the 3-bar plastic slide.
1.
Weave webbing back through sewn-in shoulder strap loop.
2.
Install 3-bar plastic slide to webbing so that it’s positioned
about an inch below rectangular plastic loop.
3.
Insert webbing, back to front, through rectangular plastic
loop and back around toward 3-bar plastic slide.
Securing the Shoulder Webbing