APE ROBOVIBE, Руководство по эксплуатации и техническому обслуживанию

Страница: 15 / 60

VIBRATORY
DRIVER/EXTRACTOR
II. PREPARATION FOR OPERATION
B. SAFETY PRECAUTIONS (CONTINUED)
37. Rounded or damaged bolt heads or nuts should be replaced so that proper
torque values may be obtained. Proper torque values are necessary to prevent
parts on this equipment from loosening and falling. Refer to Torque Chart, in
this manual, for proper values.
38. Careful when using vibrator clamp to move piles. Loss of hydraulic pressure
could cause piles to fall.
39. Never clamp vibrator to pile and disconnect from excavator. Loss of hydraulic
pressure could cause vibrator to fall. Lay vibrator down when not in use.
40. When extracting piles, always attach a safety line between pile and the
excavator.
41. When extracting piles, check excavator load/radius tables to be sure capacity is
adequate for maximum allowable extraction pull.
42. When extracting piles, or any other driving operations, always be sure that the
excavator bucket pivot pin is aligned with the centerline of the pile. Do not side
load the vibrator. Dangerous vibrator damage may result.
43. When extracting piles, do not exceed the capacity of the vibrator suppressor.
44. Check vibrator suppressor for broken, or damaged, elastomers daily. Do not
operate vibrator with damaged elastomers.
45. Never pull on a vibrator before starting the unit in vibration. Always start both
driving and extraction of piles in an unloaded condition.
46. Keep hands away from clamp jaws.
47. Keep hands away from vibrator suppressor during operation. Clearances may
change causing pinch points.
48. Do not run vibrator unless clamp jaws are closed.
49. Use a tag line to control vibrator whenever possible.
REMEMBER, SAFETY IS EVERYONE'S BUSINESS.
C. RIGGING OF VIBRATOR
1. EXCAVATOR PREPARATION
WARNING : ALWAYS BE SURE THAT EXCAVATOR PARTS, AND/OR
ROBOVIBE, ARE FULLY SUPPORTED WHEN REMOVING MOUNTING
PINS, TO PREVENT SUDDEN SHIFTS AND INJURY.
a. Remove bucket pivot pin, bucket link pin and bucket..
b. Remove bucket linkage pins from stick (dipper arm) and bucket
cylinder pin (rod end). Remove bucket linkage.
2. ROBOVIBE INSTALLATION
a. The Rototilt mechanism can be custom ordered with bushings to fit a variety
of excavators. Check the Rototilt yoke to be sure that the ears fit onto the
excavator stick, in the area of the bucket pivot. Axial play of the yoke
should not exceed ½”(12mm).
II-3