OPERATING
INSTRUCTIONS
IV-3
MODEL 100
BOTTOM DRIVE
WICK INSERTER
IV.
MAINTENANCE AND ADJUSTMENTS
E. LUBRICATION
1. Hydraulic
System
To maintain the maximum operating effi ciency in the precision parts of the hydraulic system,
it is extremely important to eliminate factors which can cause breakdowns or unsatisfactory
performance in the system. Among the most common of these factors are rust, corrosion,
contamination and products of oil deterioration. Most problems can be minimized or avoided
simply by maintaining a disciplined preventive maintenance program.
Some simple steps to follow as part of that program are:
a. Keep stored oil dry and clean at all times and always store in clean containers.
b. Always clean tools, spouts, lids, funnels, etc. when used in conjunction with the transfer
of oil.
c. Never put dirty oil into the hydraulic system. Use only clean, uncontaminated oil. Never
return to the system any fl uid which has leaked out.
NOTE:
Foreign material in the hydraulic system can drastically effect the life
and operation of many hydraulic component parts.
d. Clean or replace fi lter elements at the fi rst indication that they are dirty or ineffective.
2. Vibration Gear Box
The fl uid level is easily read through the sight glass located at the lower center of the
vibration case on the motor side. Lubricating oil may be added when necessary, through
the hole in the vibration case top plate after removing the 1” pipe plug. To drain the case,
remove a 1” pipe plug at the end of the base plate. Tilt the case for complete drainage. The
capacity of gear oil is 9 quarts.
Содержание 100 WICK
