APart-Audio SDQ5Pir, Руководство пользователя

Страница: 6 / 12

WWW.APART-AUDIO.COM
6
Restore Factory Settings:
The factory defaults are shown in the RS232 commands table. In order to restore the factory default
settings, enter the following command: SET RESTORE ON<CR>
This function can also be executed without using RS232 commands. In that case, power off the speaker.
While pushing BASS + and - buttons on the rear panel simultaneously, power up the speaker with the
power switch. The multifunction led will be orange. Release the BASS + and - buttons one second after
powering up. All factory defaults will be restored.
Standby:
The SDQ5Pir can be switched to Standby mode with the IR remote control or with the “SET STANDBY
ON<CR>” instruction. Leaving Standby mode can also be done with IR remote controller or the “SET
STANDBY OFF<CR>” instruction. If an RS232 instruction is sent when the amplifier is in Standby mode
or during power on, and the amplifier is not ready, it will answer “STANDBY ON”. Please wait until the
speaker is operational (green led at the back is lit) and resend the instruction.
When the SDQ5Pir is in standby mode, the AUPTRG function will not be able to wake up the speaker.
In standby mode, the SDQ5Pir can only be activated by a SET STANDBY OFF command.