Intelligent
Remote
Control
Cleaning time /Air volume output adjustable
Cleaning time setting
Set a reminder for the cleaning time at will. Blue light flashes indicates cleaning is required. The electrode needle
cleaning cycle should be set according to the working environment when using the ionizing air blower. Cleaning
cycle should be shorten appropriately in environment with more moisture and dust.
Air volume output adjustable
Fan speed in five gears. Adjust the air volume according to the installation distance of the static eliminator and the
status of the target object.
Ion balance adjustable
The ion balance voltage can be adjusted by adjusting the negative high voltage
amplitude remotely.
Function
Symbol
Operation instructions
Unlock
Unlock before adjusting operating parameters; 30s delay if any key is
pressed, exit and re-locked if no key is pressed.
Run
/
Pause
Device starts running when power is on. Press "STOP" to standby and no
high voltage output. Press "RUN" again and the device will start working.
Clean
Press the button to clean the needle once.
Adjust clean time
CT
TH
→ +/-
Press CT
TH
first, and then press +/- to increase or decrease the
cleaning cycle. Minimum adjustment unit 1H.
Adjust air volume
CFM → +/-
Press CFM first, then press +/-,air volume from high to low is 1,2,3,4,5.
Adjust ion balance
IB
N
→ +/-
Press IB
N
first, then press +/- to adjust the ion balance voltage.
Confirm
CAL → OK
Note: Press CAL first, then press OK to confirm after adjusting the
output parameter; otherwise, false alarms are likely to occur.
Reset
Reset
（150Hz、50%、4H）：
Press
CAL
first
，
then
press
Press IB
N
first, then press + when the positive voltage on flat panel charge detector or object surface is high, press IB
N
first, then press - when
the negative voltage on flat panel charge detector or object surface is high
u
ntil the ion balance reaches the ideal status.
CAL →
TIME
TIME
Reduce
the negative high voltage amplitude
,
the negative ion output decreases
Adjust ion balance voltage
Button Function
instructions
