5
LEAK TESTING
NEVER USE A NAKED FLAME TO CHECK FOR LEAKS.
NEVER LEAK TEST WHILE SMOKING.
The gas connections on this appliance are leak tested at the factory prior to shipment.
This appliance needs to be periodically checked for leaks and an immediate check is
required if the smell of gas is detected.
Make a soap solution using 1 part of liquid dish-washing soap to 3 parts water.
The soap solution can be applied with a soap bottle, brush, or rag to the leak
tested points shown in the figure.
The valve of the gas cylinder should be in the
OFF
position at this point of the
leak test. Once the soapy solution is applied to the gas connections, the valve of
the gas cylinder needs to be turned to the
ON
position.
Soap bubbles will begin to form in the soapy solution if a leak is present.
In case of a leak, turn off the gas supply. Tighten any leaking fittings, then turn
the gas supply on and recheck.
OPERATING INSTRUCTIONS
BEFORE FIRST USE AND AFTER EVERY GAS CYLINDER CHANGE, GAS DELIVERY SYSTEM MUST BE
PURGED OF AIR BEFORE IGNITING! TO DO THIS, TURN THE CONTROL KNOB ANTI-CLOCKWISE TO THE
PILOT SETTING. PRESS KNOB IN AND HOLD FOR ABOUT 2 MINUTES BEFORE ATTEMPTING IGNITION.
BATTERY REPLACMENT
Remove impulse ignition cap from below Ignition by turning cap counterclockwise. Install 1 AAA battery.
Negative end of battery goes in first, then replace impulse ignition cap by turning cap clockwise.
TO LIGHT THE PILOT
Check all connections prior to each use.
Turn on main gas supply at source.
Press to turn control knob anti-clockwise to PILOT.
Hold knob depressed, press the knob repeatedly until pilot
flame is lit, then continue to hold the knob depressed for
20
seconds until the pilot remains it after releasing knob.
If pilot fails to ignite or alight, press to turn knob clockwise to
OFF
and repeat.
TO LIGHT THE APPLIANCE
The pilot should be lit and the knob set to
PILOT
.
Hold knob depressed gently and turn anti-clockwise to
HIGH
.
When the appliance glows lit, turn knob clockwise from
HIGH
to
LOW
as needed.
RE-LIGHTING
Turn Control Knob to OFF.
Wait at least 5 minutes to let gas dissipate, before attempting to re-light pilot.
Repeat the “Lighting” steps.
