6. CHASSIS
Step 3
:
Locate and seat the new valve tubeless tyre at rim valve hole
Step 3
Step 4
from the other side of the rim.
Step 4
:
Insert a suitable mandrel type tool and gently tap to ensure
proper seating of the valve
REMOVAL AND ASSEMBLY OF TUBELESS TYRES
Incase of tyre removal from the wheel rim, remove the wheel assembly as like Apache RTR. After rem ving the wheel assembly from the
vehicle, careful removal of tubeless tyre is necessary using a tyre demounting machine to remove the tyre from the wheel rim. Use of
levers used for removing normal tyre in the puncture shop may cause damage to the rim and will result in improper sealing and loss of air.
REMOVAL AND REASSEMBLY OF FLAP REAR FENDER
Rear fender with Flap
Rear fender without Flap
Flap rear fender
F nd r r ar
Follow the steps below for removal and re-assembly of Flap Rear Fender
Step 1:
Loosen and remove 1 no. of reflector mounting nut (A) from the
flap rear fender using 8 mm spanner.
Step 2
:
Loosen and remove 1 no. of CRR pan head screw (B) from flap
D
rear fender bottom mounding using a phillips screw driver.
Step 3:
C
Loosen and remove 2 nos. of bracket license plate mounting
nuts (C) using a 10 mm spanner and remove the bracket along
B
with the Licence plate.
(Do not separate the Licence plate
from its bracket)
A
Step 4:
Finally loosen and remove 2 nos. of Hex. head
bolts (D) from flap rear fender top mounting using a 10 mm
spanner and remove the Flap.
Step 5 :
Now assemble the bracket license plate along with license plate
Bracket
1
and reflector on rear fender at the respective locations of the
rear fender (Marked 1 & 2)
lic nse
plate
To reassemble the Flap rear fender, first remove the bracket
mountings
license plate and reflector. from the rear fender. The locate the
Reflector
flap rear fender over the rear fender matching the mounting
2
locations (Refer A,B,C,D in fig.) and tighten the bolts, screws
Mounting
and nuts as applicable.
-9-