Apach BAKERY line V Series, Инструкция по эксплуатации и техническому обслуживанию

Страница: 69 / 97

EN
69
TIMER BYPASS SELECTOR
Normal operating conditions::
To permit the machine to function normally, i.e. to
activate all the machine functions present on the
control panel, it is necessary to turn this selector to
the right onto the clock symbol.
Backup operating conditions (to be used only in the
presence of a faulty timer):
In the case of a fault in the timer, it is possible to
work in a backup mode for a limited period of time,
only until the fault is repaired. In particular, turning
the selector to the left onto the broken clock symbol,
it is possible to bypass the timers and use the mixer in
2nd speed in manual mode.
EMERGENCY-STOP BUTTON
The rotation of the bowl and of the spiral tool can be
stopped by pressing the Emergency button.
To restart the machine, it is necessary to first remove
the emergency condition, by rotating the same push
button clockwise until it is released, then press the
start button.
The timers are reset.
OPERATING MODES
The mixer can run in three modes, when the mobile bowl cover is closed:

Manual mode;

Semi-automatic mode;

Automatic mode.
These operating modes are selected using the special timer composed of a first speed dial (located to the
left) which has a scale of 0-10 minutes and a second speed dial (located to the right) which has a scale of
0-20 minutes. Each timer has three settings:

Count:
If the timer dial is set above the 0 marking, then the LED corresponding to this setting lights up
and flashes when the START button is pressed and the time countdown begins. In this setting the
machine works for the time set and in the speed corresponding to the specific dial (first speed for
the left dial and second speed for the right dial)

Manual:
If the timer dial is set below the 0 marking, then the LED corresponding to this setting lights up. In
this setting the machine works in manual mode, i.e. in the speed corresponding to the specific dial
until the Emergency button is pressed to stop the work cycle.

Excluded:
If the timer dial is set on the 0 marking, then the LED corresponding to this setting lights up. In this
setting the timer is switched off and it is not possible to work in the speed corresponding to this
dial.