56
PNP/PCI Configurations > Assign IRQ For USB
In case conflict occurs after you assign the IRQs or after you configure your
system, you can enable this function, allow your system to automatically reset
your configuration and reassign the IRQs, DMAs, a
nd I/O address.
Available options:
Disabled
,
Enabled
Silent BIOS/HW Monitor
This submenu displays Silent BIOS / HW monitor status and provides some basic
control function.
Silent BIOS/HW Monitor > CPU Warning Temperature
This item is used to specify a CPU warning temperature. When the CPU’s
temperature is higher than this predefined value, the CPU’s speed will
automatically slow down and there will be a warning from BIOS.
Silent BIOS/HW Monitor > CPUFan Boot Speed
Silent BIOS/HW Monitor > SYSFan Boot Speed
Silent BIOS/HW Monitor > Fan Mode
This item allows user to select the mode of Fan Speed. Available options:
z
Full Speed:
All fans will operate in full speed.
1.
If CPUFAN doesn’t be connected or operate, there would be Warning Beep.
2.
When SystemFAN or PowerFAN is connected to motherboard, if
SystemFAN or PowerFAN doesn’t work, there would be Warning Beep.
z
Smart Control:
User could set critical temperature for each fan. If the
temperature is under critical temperature, fan wouldn’t operate; on the
contrary fan would operate.
1.
If Power Temperature connector isn’t be connected, Smart Control.mode
for Power Fan will be disabled.
