13. Support 2
nd
USB Port
14. NMI (Non-Maskable Interrupt) Switch Jumper
11. Connecting Front Panel Connector
Attaching such as power LED, reset switch, power switch connector, etc.… to
corresponding pins.
12. WOL (Wake on LAN) Connector
To use Wake On LAN function, you must have an Ethernet card with chipset that
supports this feature, and connect a cable from LAN card to motherboard WOL
connector. The system identification information (probably IP address) is stored on
network card and because there is a lot of traffic on the Ethernet, you need to install
network management software, such as ADM, for the checking of how to wake up the
system.
Non- Maskable Interrupt used for event handling. When event is occurred, system will
receive an NMI and execute a unique task. To disable this function, please short CN18
by jumper cap.
This motherboard supports four USB ports. Two of them are on back panel connector, the
other two are on the left-bottom area of this motherboard. With proper cable, you can
connect them to front panel.
+5VSB
GND
LID
USBPWR6
USBP2-
GND
USBPWR7
USBP2+
USBP3+
USBPWR8
USBP3-
GND
USBPWR5
Open
(Default)
Close
ATX
Power Switch Power LED
Reset Switch
HDD LED
Chassis
Intrusion Switch
1
2
21
22
+5VSB
GND
HDD LED
GND
+5V
+5V
PWR LED
HDD LED
+5V
INT S/W
RST S/W
GND
GND
1
2
21
22
