AWARD BIOS
3-30
Integrated Peripherals
à
Onboard Serial Port 1
Integrated Peripherals
à
Onboard Serial Port 2
Onboard Serial Port 1
Auto
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Disabled
This item allow you to assign address and interrupt
for the board serial port. Default is Auto.
Note: If you are using an network card, make
sure that the interrupt does not conflict.
Integrated Peripherals
à
Onboard UART 2 Mode
Onboard UART 2
Mode
Standard
HPSIR
ASKIR
This item is configurable only if the "Onboard
UART 2
"
is enabled. This allows you to specify
the mode of serial port2. The available mode
selections are:
•
Standard
-
Sets serial port 2 to operate in normal mode. This is the
default setting.
•
HPSIR
-
Select this setting if you installed an Infrared module in your
system via IrDA connector (refer to section 2.3 "Connectors"). This
setting allows infrared serial communication at a maximum baud rate of
115K baud.
•
ASKIR
-
Select this setting if you installed an Infrared module via IrDA
connector (refer to section 2.3 "Connectors"). This setting allows infrared
serial communication at a maximum baud rate of 19.2K baud.
