13
Set-Up
Inserting Batteries into the Remote control
Insert two size AA batteries (supplied) to the diagram inside the battery compartment of the remote control.
Attaching the Base
IMPORTANT:
The Base of the AOC LCD TV must be assembled prior to usage.
Place the TV set facing down on a soft and flat surface (blanket, foam, cloth, etc.) to prevent any
1.
damage to TV set.
Carefully align and insert the Base to the stand
2.
Secure the screws on the bottom of the base.
3.
Please refer to the “Important Usage instructions” in the above.
4.
Wall-Mounting
Please install on a wall by using a Wall-Mount Bracket (sold separately). Before mounting the TV on a wall, the Stand must be removed from the
TV. Follow the simple steps below to remove the Table-Top Stand:
Disconnect all the cables from the TV.
1.
Gently lay the TV, face down, onto a level and stable surface covered with a thick and soft cloth. Make sure the Stand is hanging over the
2.
edge.
Remove the screws as shown in the illustration for your model and pull the Stand out.
3.
Do not remove any other screws from the TV.
4.
Do not remove the Stand for any reason other than to Wall-Mount
5.
the TV.
Be sure to store the removed screws and Stand in a safe place until you are ready to reattach the Stand. Keep the screws away from small
6.
children.
For bracket installation, refer to the instruction guide provided by the Wall-Mount
7.
Bracket model for your TV. Sufficient expertise is required in
installing this TV, especially to determine the strength of the wall for withstanding the TV’s weight.
For product protection and safety reasons, AOC strongly recommends that you use the Wall-Mount
8.
Bracket model designed for your TV and
the Wall-Mounting of your TV should be performed by AOC dealer or licensed contractor.
1
2
3
Note: Wall mount bracket & screws (Screws length: 10mm and pitch: 0.7mm) are not included.
Please contact your local distributor.
