Anywave MPTV, Руководство пользователя

Страница: 34 / 96

MPTV V1 TX User Manual
MPTV-V1-1KW-USR-DOC-V1.0, 05/25/2018 Page 34 of 96
11. To turn the TX On/Off, please use the TX On/Off button located on the HOME
screen of the Control module or via the TX built in web interface. When turning the
TX OFF and ON again, monitor the FWD power wattage on the HOME screen as
FWD power ramps up to the AGC target level (45-60 seconds).
12. To Raise or Lower the TX output power level, please adjust the AGC target power
setting under the Controller Config

AGC button. An alternative to this would be
to disable the Controller AGC (set AGC-Status = Off) and raise/lower the Exciter
output drive.
13. You may network your Transmitter Control Module (rear LAN connector, default
ipaddress 192.168.1.210) and your Exciter (REMOTE RJ-45 rear panel connection
at 192.168.1.143), and your PA drawers (front LAN port 192.168.1.200 – note –
you will need to change some of the PA IPaddress (via the PA built-in web interface)
to avoid network conflicts if putting all PAs on your network for remote
monitor/control. All equipment ipaddresses are user configurable via their
respective user interfaces, so they may be configured to match the TX sites specific
ipaddressing scheme.
If you desire to have remote monitoring and control, before leaving the station,
please be sure to set the Transmitter to REMOTE mode via the Controller CONTROL
button setting and set the Exciter to REMOTE mode under the SYSTEM submenu by
setting CTL=RMT. This will enable remote monitoring and control of the TX via its
built-in web interfaces (refer to the 1KW TX and Exciter user manuals for details).
Set Target AGC to
desired System
Forward Power,
Turn AGC
ON/OFF