Page 3 of 11 Anyload-manual-indicator-DD-KC1-en-101
the Maximum Capacity and
Division
. After the screen displays
“0”, you can begin to
measure the object.
When power-on, press
button to turn off the scale.
4.2 Instruction for load cell connection
4.2.1 Connection of the load cell
The connection of the four wire load cell and the indicator
：
CEXC with the red wire of the indicator’s cable.
Connect
–EXC with the black wire of the indicator’s cable.
CSIG with the green wire of the indicator’s cable.
Connect
–SIG with the white wire of the indicator’s cable.
The indicator provides driving voltage tEXC wire and
–EXC wire. +SIG
wire and
–SIG wire will transmit the change of signal voltage to the indicator.
*To avoid short circuit, please make sure the welding parts of all the wires
covered by the heat shrinking tube.
Figure
：
Connection of the Load Cell and the indicator
4.2.2 Load cell output sensitivity:
1
～
2m V
／
V
4.2.3 Factory parameter setting.
1. Turn off the scale, then hold the three buttons:
,
and
at the
same time until the screen displays
“------”
；
2. Press
or
button to go through the menu
；
3. Press
button to enter the display menu.
；