ANVL BOARDS
Visit www.anvlboards for instructional videos
Disassembly:
Remove all the screws
(both sides) as indicated above. There
are two hex key sizes, a 2.5mm and
5mm. There are 11 screws and 2 screw
posts.
Keep track of loose screws.
Disassembly:
Pull apart halves from
the front (a). Repeat step 3 to release
remaining side.
Be careful of loose spacers falling out.
Disassembly:
Use the retainer tool to
push out the retainer. Press near a
bearing from the side of the retainer
with the opening.
Disassembly:
Use the retainer tool to
slide bearings to the bottom (see fig.7)
allowing the inner rim to be pulled out.
Keep track of loose bearings.
Disassembly:
Unscrew from the bot-
tom. Partially loosen Neck Pin screw.
Push Neck Pin screw to release the
pin. Continue removing screw and pin.
Set aside Neck and Cross Bar. They do
not need to be disassembled further.
Disassembly:
Before you pull the two
halves apart, hit the end (as shown
above) with your palm until you see a
slight separation of the two halves.
WARNING: Your Skatecycle warranty may be voided by improper or incorrectly performed maintenance or repairs. It is strongly recommended that servicing and repairs
be handled by a qualified bicycle mechanic.
1
2
3
4
5
6
Содержание Skatecycle
Страница 1: ...Skatecycle Instructions...
