UNIVERSAL TOASTER UTX-200
13
P/N 1010904 Rev. 4 11/18/05
McDonald’s
Daily Cleaning
1. Turn the Rocker Switch (power On/Off) to OFF
(Figure 5). The red light on the switch will turn
off.
2. The fans will continue to run with the display
reading
Cleaning Mode
. The Cleaning Mode
will continue for 45 minutes and completely shut
the unit down automatically when complete.
3. Using Heat Resistant Gloves, r
emove the following
items from the unit (refer to Figure 1):
• Bun Buffer
• Top Bun Feeder
• Breakfast Feeder
• Release Sheet and Retainer
• Crumb Tray
4. Wash the items listed above in hot, soapy water,
rinse in clean water, and allow to air dry. Then
wipe these parts with a clean cloth dampened
with Sanitizer and allow to air dry.
6. Remove the Release Sheet from the Release
Sheet Retainer (Figure 1). Lay the Release
Sheet on a clean, flat, dry surface. Spray
McD©
All-Purpose Super Concentrate (APSC II)
(HCS)
on a clean, dry towel. Wipe the towel
firmly across the Release Sheet lengthwise over
its entire surface. Immediately, repeat this pro-
cedure with a clean, dry towel dampened with
KAYQUAT™ Sanitizer (HCS)
solution and allow
the Release Sheet to air dry. Turn the Release
Sheet over and repeat this cleaning procedure on
its other side.
7. Turn the two Back Panel Release Latches so
they are in the vertical position and open the
Back Panel (Figure 15).
8.. Apply McD© All-Purpose Super Concentrate
(APSC II) (HCS) on a green non-scratch pad and
clean the metal Conveyor Belt for two complete
revolutions (use the holes in the master links as a
reference).
9. Rinse/wipe the Conveyor Belt with KAYQUAT™
Sanitizer (HCS) solution and allow to air dry.
MAINTENANCE
WARNING
The unit will remain hot to the touch while it is
cooling down. Personal injury and burns may
result from touching the unit before it is finished
cooling down.
NOTE: If the Conveyor Belt appears yellow/brown,
repeat Steps 8 and 9 until the build up is removed.
The belt should be silver/metallic when cleaned
properly.
NOTE: If necessary, press and hold both Muffin/
Bagel buttons on the back of the unit (Figure 5) to
advance the belt for exposing uncleaned belt.
10. Wipe the entire exterior surface to the toaster with
a clean, dry towel, dampened with
KAYQUAT™
Sanitizer (HCS)
and allow it to air dry.
NOTE: Be sure to wipe the bun drop area clean as
well!
11. Insert the Release Sheet Retainer into the top of
the Release Sheet.
12. Hang the Release Sheet Retainer and Release
Sheet onto the top of the unit. The Release
Sheet must be inserted between the Platen and
the two Side Brackets of the unit so it will not be
pinched by the Platen Conveyor (Figure 1).
13. Reassemble all accessories onto the unit accord-
ing to Figure 1.
NOTE: Check the Release Sheet to make sure that
it is draped properly over the Platen Grill.
9. Verify that the Bun Thickness Compression
Controls are set to either 4 or 5.
10. Close the Back Panel and lock the Back Panel
Release Latches.
NOTE: Refer to the cleaning label located on the
back of the unit.
Figure 15. Back Panel Release Latches
Release Latches are locked when in the horizontal
position. Turn the latches to the vertical position to
open the Back Panel
SELEC
T
SELEC
T
