Antunes HEBT-3V, Руководство пользователя

Страница: 5 / 28

HEBT-3V BUN TOASTER
5 P/N 1011328 Rev. I 04/18
McDonald’s
Location
When placing the toaster into service, pay attention to
the following guidelines:
• Make sure power is off and the toaster is at room
temperature.
• Do NOT block or cover any openings on the unit.
• Do NOT immerse cord or plug in water.
• Keep cord away from heated surfaces.
• Do NOT allow cord to hang over edge of table or
counter.
1. Place the toaster in the required position desig-
nated by McDonald’s.
2. Attach the Bun Feeder, Bun Buffer Frame, and
Crown\Heel Separator accessories (Figure 1.)
3. Plug the power cord into an appropriate power
outlet. Refer to the specification plate for
the proper voltage.
Unpacking
1. Open the large box. It contains:
• HEBT-3V toaster
• Accessories box
2. Remove the accessories box from the large box.
3. With the help of another person, carefully remove
the HEBT-3V from the large box.
4. Remove all protective coverings from the unit.
5. Open the Accessories Box. It contains:
• Owner’s Manual
• Bun Buffer Frame
6. Wipe the entire exterior of the toaster and the
accessories mentioned above with a clean towel
sprayed with a McDonald’s approved sanitizer.
Allow to air dry.
NOTE: Handle accessories with care. If an accesso-
ry becomes bent or damaged, it may not attach to
the unit correctly, which may affect normal opera-
tion.
NOTE: If any parts are missing or damaged, con-
tact A.J. Antunes Customer Service IMMEDIATELY
at +1-877-392-7854 (toll free).
INSTALLATION
Bun Buffer
Frame
Rear
Conveyor
Cover
Figure 1. HEBT-3V Components
Control
Panel
(Side of unit)
Front Conveyor
Cover and Feeder
Assembly
Compression
Knob