Antunes 9210914, Руководство пользователя

Страница: 5 / 24

®
P/N 1011436 Rev. H 02/21
5
Installation
Unpacking
1. Remove unit and all packing
materiRemove unit and all packing
materials from shipping carton.
2. Open the included large box. It should
contain the following (See Figure 3):
• Bun Chute
• Butter Wheel and Pan
(Mfg. No. 9210914)
• Bun Feeder
• Two guttered Release Sheets
• Platen Cleaning Tool
• Owner’s Manual
• Maintenance Card
3.
Remove all shipping tape and
protective coverings from the unit and
parts.
NOTE: Missing or damaged parts?
Contact Antunes Customer
Service at +1-877-392-7856 (toll
free).
Equipment Setup
Before placing the toaster into service, pay
attention to the following guidelines:
y
Make sure power to the
unit is off and the toaster is
at room temperature.
y
Do NOT block or cover any
openings on the unit.
y
Do NOT immerse cord
or plug in water.
y
Keep cord away from
heated surfaces.
y
Do NOT allow cord to hang
over edge of table or counter.
y
Connect the unit to the proper
power supply. Refer to the
specification plate for proper voltage.
Assembling the Unit
NOTE: The factory has pre-installed
a Release Sheet over the
Platen (Figure 3). Verify that
it is properly in place before
proceeding.
Figure 1. VCTM-2
CAUTION
Failure to use Release Sheets may
result in damage to the unit and loss of
warranty coverage.
Installing Butter Wheel Assembly (Mfg.
No. 9210914 ONLY)
1. Remove Butter Wheel and Pan from
box.
2. Install the Pan over the front edge of
the Bun Feeder and place the Butter
Roller in Pan and engage into gear
case (Figure 2).
3. Fill the Butter Pan with Butter before
toasting.
Installing the Bun Chute
1.
If the unit is on, be sure to put on heat
resistant gloves.
2.
Insert the Bun Chute through the front
of the unit according to Figure 2.
3.
Hang the back of the Bun Chute on
the rear Conveyor Cover hinge. When
properly installed, the Bun Chute
supports will be flush against the front
of the unit (Figure 2).
NOTE: You may need to stand to the
side of the unit to guide the Bun
Chute into place from the front
and rear using both hands.
Rear
Conveyor
Cover Hinge
Insert Bun Chute
through front of unit.
Bun Chute is properly
installed when it hangs
from the rear Conveyor
Cover hinge.
Figure 2. Installing Bun Chute