Antunes 9210840, Руководство пользователя

Страница: 5 / 24

HEBT-5V BUN TOASTER
5 P/N 1011112 Rev W 05/22
McDonald’s
Location
When placing the toaster into service, pay attention to the
following guidelines:
y
Make sure power is off and the
toaster is at room temperature.
y
Do NOT block or cover any openings on the unit.
y
Do NOT immerse cord or plug in water.
y
Keep cord away from heated surfaces.
y
Do NOT allow cord to hang over
edge of table or counter.
1.
Place the toaster in the required position
designated by McDonald’s.
2.
Attach the Bun Feeder, Angular Bun Feeder (if
present), Bun Buffer Frame, and Crown\Heel
Separator accessories (Figure 1).
NOTE: Be sure to attach the Bun Feeder so the tabs are
seated properly. Failure to attach the Bun Feeder
properly could cause serious damage to the
toaster.
3.
Plug the power cord into an appropriate power
outlet. Refer to the specification plate for the proper
voltage.
NOTE: See “Angular Bun Feeder (Some Models” in the
Operations section of this manual for information
on using the supplementary Angular Bun Feeder
(some models).
Unpacking
1. Open the large box. It contains:
y
HEBT-5V toaster
y
Accessories box
2. Remove the accessories box from the large box.
3. With the help of another person, carefully remove the
HEBT-5V from the large box.
4. Remove all protective coverings from the unit.
5. Open the Accessories Box. It contains:
y
Owner’s Manual
y
Angular Bun Feeder (some models)
y
Bun Buffer Frame
y
Club/Heel Separator
6. Wipe the entire exterior of the toaster and the
accessories mentioned above with a clean towel sprayed
with a McDonald’s approved sanitizer. Allow to air dry.
NOTE: Handle accessories with care. If an accessory
becomes bent or damaged, it may not attach
to the unit correctly, which may affect normal
operation.
NOTE: If any parts are missing or damaged, contact
Antunes Customer Service IMMEDIATELY at +1-
877-392-7856 (toll free).
Figure 1. HEBT-5V Components
(Belts not Shown)
Bun Feeder
Angular
Bun Feeder
Some Models)
Bun Buffer
Frame
Club/Heel
Separator
Rear
Conveyor
Cover
Control
Panel
Front
Conveyor
Cover
Compression
Knob
Installation