ANTTI A170, Инструкция по установке и эксплуатации

Страница: 13 / 22

12
Antti-heaters
1/2005
Points to note before putting the machine into operation:
- The burner mechanics and electricians have carried out the test run.
- The oil tank is filled with clean light-oil.
- There are no objects in the heater room that do not belong there.
- The air inlet piping of the heater is in place and only clean air comes to the fan.
- The shutter valves in the oil piping are in open position
- Check once more that the main switches and any safety switches are at the ON-position
- There is a manually operated fire extinguisher outside the heater room during the drying
procedure.
OPERATING INSTRUCTIONS OF THE HEATER
Output adjustment
- If necessary, the amount of drying air is reduced with the regulator in the suction piping.
- The required drying air temperature is adjusted to desired value by changing the setting of
the 2-effect thermostat or the digital thermostat. In the digital centre, the adjustment is made
with the buttons of the digital thermostat.
- In the 2-effect burner the amount of burning air is adjusted automatically to correspond with
the oil consumption (in accordance with the linear adjustments, which are set during the
installation of the burner).
- The change of nozzles and the adjustment in the amount of burning air is carried out in
accordance with the instructions given in the operation manual of the burner.
WARNING! Make sure that the burner is de-energized before opening it. High tension in
the burner Risk of fatal electric shock
- Before starting the cooling process after drying, the oil burner is either switched off with
the switch in the electric centre, or is automatically switched off by the drying automation
thermostat (provided that the heater is connected to the automatic control centre).
- The heater fan will not stop - not even from its operating switch - before the heater has
cooled down (the heater fan must not be switched off from the main switch before the
heater has cooled down).