SXM-100 Commercial Satellite Audio Receiver
36
Selecting an invalid channel will set the display to “???”
and the cursor will not move off this field until a valid channel
number is entered.
Selecting “*VOL” allows for a volume change applied to the
current audio channel at the programmed time – a feature
useful for decreasing the audio volume during slow hours of a
restaurant or bar. Three levels of locking access to manual
channel changing can be programmed with “*LK0”, “*LK1”,
and “*LK2”. These options are explained in more detail above.
Turning off the unit at a specified time (*Off) may also be
programmed. Note that subsequent to a programmed “Off”
period, any valid forced tune event to a channel will turn the
unit back “On”. An existing event is deleted by choosing *DEL
in this field.
When finished reviewing, adding, or deleting Forced
Tune events with this menu, pressing the SEL button on the
remote will prompt to save the changes. Selecting either Yes
or No will return you to the Edit or Add New screen. Pressing
the MODE button will exit and
not
save any changes.
Software Version
If you press the Mode key when the menu reads “SETUP – SW
VERSION”, you should see a submenu similar to the following:
Pressing the Mode key again will exit the submenu.
Passcode Menu
Certain features of the SXM-100 are protected from
unauthorized access by a passcode. By default, as shipped
from the factory, the passcode is 1234. To access these
features, press and hold the MODE button on the front panel
for 4 seconds or press the SETUP key on the remote control to
enter the Setup menus. Use the UP or DOWN buttons to
navigate to:
VER 7.00.003
