HYDRAULIC CALLIPER TYPE NHCD-1400
Instructions for assembly, adjustment and maintenance
T.D.S.: BC.TDS.00025I
Rev.0.: September - 2012
A number of general safety rules must be taken into account when handling ANTEC
brakes:
1-. All workers and technicians must wear appropriate gear when handling the brake
(safety clothes, boots, helmet, goggles, etc.).
2-. Always keep warning signs (if any) on the brake in good condition and adhere to
them. During repairs or maintenance, place a warning sign to inform other workers that
an ANTEC brake is being repaired in that machine, and that the power supply has been
disconnected, if applicable.
3-. Find out the exact specifications of the liquids used to prevent health problems and
ensure safety.
4-. Make sure all electrical apparatus (if any) is properly grounded to prevent electric
shocks.
5-. Rigorously adhere to the limits set for each brake component and for the brake itself.
6-. Before switching on any machine fitted with ANTEC brakes, ensure that the brake is
fully applied and tightened with the required torque.
7-. ANTEC does not accept any liability for the use and maintenance of the tools that
the customer uses to assemble and handle the brakes.
Danger of death: This symbol will be included at
points or in paragraphs that need special
attention. It usually refers to an operation that
might involve a death hazard.
High temperatures: This symbol will be included
at points or in paragraphs that need special
attention. It usually refers to an operation that
might involve danger of high temperatures.
This symbol will be used to highlight an
important comment or piece of information.
NOTE
