Antaira Technologies - Industrial Ethernet Switches
LNX-C800G Series User Manual V1.0
8
3. Mounting Installation
3.1 DIN-Rail Mounting
The DIN-Rail is pre-installed on the industrial Ethernet switch
from the factory. If the DIN-Rail is not on the industrial Ethernet
switch, please refer to
Figure 3.1
to learn how to install the DIN-
Rail on the switch.
Follow the steps below to learn how to hang the industrial Ethernet switch.
1. Use the screws to install the DIN-Rail bracket on the rear side of the industrial Ethernet
switch.
2. To remove the DIN-Rail bracket, do the opposite from step 1.
3. After the DIN-Rail bracket is installed on the rear side of the switch, insert the top of the DIN-
Rail on to the track as shown below in
Figure 3.1.2
4. Lightly pull down the bracket on to the rail as shown below in
Figure 3.1.3
5. Check if the bracket is mounted tightly on the rail.
6. To remove the industrial Ethernet switch from the rail, do the opposite from the above steps.
7. Check if the bracket is mounted tightly on the rail.
Figure 3.1.1
The Rear Side of the Switch and DIN-Rail Bracket
Figure 3.1.3
Stable the Switch on DIN-Rail
Figure 3.1.2
Insert the Switch on the DIN-Rail
