Antaira Technologies - Industrial Media Converters
IMC-C1000-XX Series - Hardware Manual - v1.2
4 Hardware Installation
4.1 Installation Steps
This section will explain how to install the industrial media converter:
Caution: This device is intended for indoor use.
Attention: Cet appareil est destiné à une utilisation en intérieur.
Caution: The device is intended to be installed in an industrial control enclosure and panel.
Attention: L'appareil est destiné à être installé dans une armoire de commande et un panneau industriels.
Installation Steps
1. Unpack the industrial media converter from the original packing box.
2. Check if the DIN-Rail bracket is screwed on the industrial media converter.
●
If the DIN-Rail is not screwed on the industrial media converter, please refer to the DIN-Rail Mounting section
for DIN-Rail installation.
●
If it is required to wall mount the industrial media converter, please refer to the Wall Mounting section for wall
mounting installation.
3. To hang the industrial media converter on a DIN-Rail or wall, please refer to the Mounting Installation section.
4. Power on the industrial media converter and then the power LED light will turn on.
●
For the help on how to wire power, please refer to the Wiring the Power Inputs section.
●
Please refer to the LED Indicators section for LED light indication.
5. Prepare the twisted-pair, straight-through category 5 cable for Ethernet connection.
6. Insert one side of the RJ45 cable into the switch’s Ethernet port and on the other side into the networking device’s
Ethernet port, e.g. switch PC or server.
●
The Ethernet port’s (RJ45) LED on the industrial media converter will turn on when the cable is connected to
the networking device.
13
