EN
21
SAFETY INSTRUCTIONS
Read the operating instructions carefully before use!
Please retain for future reference.
• The manufacturer is not responsible for injury or damage arising due
to incorrect use.
• Incorrect or inappropriate use may result in personal injury or material
damage.
• Never open the light’s casing. There are no parts that can be repaired
or replaced.
• Never immerse the light in water or any other liquid.
TECHNICAL DATA
Light source
2 x LED 1 W (LEDTS-140-2-DC)
Batteries
4 x AA (not included)
Enclosure class
IP44
Sensor range
Horizontally at 140°, approx. 3 m / Horizontally at 90°, approx. 12 m
INSTALLATION
1.
Remove the wall bracket from the light by undoing the screws below the cable box. The
screws must remain in place. (Fig. 1)
2.
Remove the wall bracket by holding the lower edge and pulling it away from the light. (Fig. 2)
3.
Use the wall bracket as a template to mark where the holes should be drilled. Attach the wall
bracket with the screws supplied. When using an electric screwdriver, start by setting it at the
lowest possible torque so that the light is not damaged. Drill the holes and insert the plugs.
(Fig. 3)
4.
Insert 4 AA batteries. Ensure they are facing the right way. (Fig. 4)
5.
Secure the light in the wall bracket. Make sure that the installation is watertight.
6.
Fully tighten the locking screws.
User instructions for
LED light with motion sensor
ENGLISH
