xMove 2.0 Ultimate
7
5.3 Lithium Batteries (Lilo/LiPo/LiFe) Program
Press “MODE/ESC“ key to the screen on the left, then press “ENTER/
START“ key to enter into the parameter setting menu. You can
switched at the same level menu by ◄ DEC/INC ► key. Please refer
the detailed flow chart on the left. When you are willing to alter the
parameter value in the program, press “ENTER/START“ key to make
it blink, then change the value with ◄ DEC/INC ► key. The value will
be stored by pressing “ENTER/START“ key once. Then press “ENTER/
START“ key for more than 2 seconds to start the process.
“AUTO CHARGING“ is for individual Lithium battery or some special
battery pack without balance port or cell count. The left side of the
first line shows the type of battery you select at the user setting. The
right side of the first line shows you the mode of charge. The value
on the left side of second line sets a charge current and the value on
the right side of second line sets the cells count of the battery. The
definition of the following screen are all the same. (To know how to
connect, please refer picture B)
“BALANCE CHARGING“ is for 2–6 cells of Lithium battery with balance
port, the battery pack being charged should have the individual
cell connect, and connect it to the individual port at the right side of
charger with a suitable connection cable that fits with your battery
pack. (see picture B) In this mode, the charging process will be
different from ordinary charging mode. The internal processor of
the charger will monitor and control the voltage of each cell of the
battery pack. This can improve the discharging performance of the
battery! xMove 2.0 Ultimate charger use the optimised calculation to
control the tolerance in the range of ±0.01 V!
“FAST CHARGING“ select this mode to finish charging process earlier
Principle: When the current down to 1/5 of the current you set
during the CV term, it will stop the process and eliminate the forcible
requirement of the balance precision. (whether it is been connected
to the balance port), the charging capacity may be a bit smaller than
normal charging but the process time will be reduced.
“STORAGE MODE“ this is for charging or discharging Lithium battery
not to be used for the time being. In order to reduce the wastage,
you can select this mode to remain the power to 40% to store. The
final voltage are different from the type of the battery, LiIo: 3.75 V,
LiPo: 3.85 V, LiFe: 3.3 V. This is an intellective program. If the voltage
of battery at its initial stage is over the voltage level to storage,
the program will start to discharge, and if it is lower, the program
will start to charge automatically. In order to ensure each battery
meets the demand, the individual plug of the battery pack should be
connected to the individual port of charger.
“DISCHARGE MODE“ the cortically, Lithium battery do not need to
discharge, especially deep-discharge. This feature is to ensure the
power wastage of the Lithium battery over 90%, to avoid the over-
charge of the individual battery, you should connect the balance plug
of the battery to the charger, and the current may not exceed 1C.
