xMove 2.0 Ultimate
11
5.6 Save Data and Load Data Program
5.6.1 Save Data
5.6.2 Load Data
5.5.2 Discharging Pb Battery
Set discharge current on the left and final voltage on the right, the discharge current ranges
from 0.1–5.0 A and the voltage should be matched with the battery being discharged. Start
the discharge process by pressing “ENTER/START“ key for more than 2 seconds.
The screen displays the current state of discharge.
Press “MODE/ESC“ key to the screen on the left, then press “ENTER/START“ key to enter into
the submenu.
The blinking (
01
) shows you the data NO, you can press ◄ DEC/INC ► key to change it.
Press ◄ DEC/INC ► key can select the type of battery, voltage, capacity and you can set them
by pressing “ENTER/START“ key, then press “ENTER/START“ key for more than 2 seconds to
select the charge mode.
Setting up charge/discharge current and final voltage.
To save the data, press “ENTER/START“ key for more than 2 seconds.
Press “MODE/ESC“ key to the screen on the left, then press “ENTER/START“ key to enter the
submenu.
You can press ◄ DEC/INC ► key to select the data number when the (
01
) field is blinking.
Press “ENTER/START“ key for more than 2 seconds, it will shows you the left screen, loading
the data.
This charger can store/load up to 10 data
of batteries, you can call out the data for
the process without setting up the program
again.
